Every now and then we come across discussions regarding the interpretation of At Risk and Immediately Dangerous situations, so for our post this week we are referring to the information given by the Gas Safe Register, as detailed on the Help and Advice page of their website:
WARNING LABELS
A registered engineer’s left a warning label on your appliance – what does it mean? When a registered engineer identifies an unsafe situation there’s a procedure they will look to follow: - the Gas Industry Unsafe Situations Procedure (GIUSP): In the first instance, they’ll look to find the cause of the problem and rectify any faults; If this is not possible, they will advise you that the fault(s) need to be repaired before the installation can be used again; If the work cannot be corrected immediately, they’ll look to make the installation safe (after receiving your permission to do so), either by disconnecting it or turning off the gas to the affected part of the installation – this is dependent on the severity of the defects
[caption id="attachment_143" align="alignnone" width="300"] Do Not Use Safety Warning Label[/caption]
Warning Labels and Defect Categories If a registered engineer has identified a gas related danger in your home, they’ll attach a Danger Do Not Use warning label to the dangerous gas fitting and provide you with a warning notice. The warning notice will show a ‘defect category.’ There are two types of defect category: Immediately Dangerous (ID): If an installation is classified as ‘immediately dangerous’ it is considered to be an immediate danger to life and property if left operating. The installation will be disconnected with your permission, and cannot be used until remedial work has been carried out to repair the defect(s). Continuing to use an immediately dangerous appliance could endanger lives. Should you refuse them permission to disconnect the installation or appliance and the appliance runs on natural gas, the gas engineer will report the situation to the Gas Emergency Service Provider (ESP). The ESP has legal powers of entry to make the situation safe, and are also able to disconnect the gas supply to the property. However, this does not apply to Liquefied Petroleum Gas (LPG) installations. At Risk (AR): If an installation is classified as ‘At Risk’ there are one or more recognised faults present which could constitute a danger to life or property without further faults developing. The installation will be turned off with your permission, and should not be used again until the fault has been corrected. There are a limited number of cases in which turning off the gas supply will not remove or reduce the risk. In such circumstances, you’ll be issued with a warning notice and advised on who to contact for further investigation.
[caption id="attachment_144" align="alignnone" width="300"] Personalised Warning Advice Notice Certificates[/caption]
Further information You may be advised that the installation does not comply to current standards. While this is something to bear in mind, it’s up to you if you choose to act on it. It’s always a good idea to bring an installation up to date, but whether you’d like this done could depend on external factors such as cost or whether you’ll be looking to have the appliance replaced in the near future. ESP Visits If the Gas Emergency Service Provider has been out to your property as a result of an emergency visit (such as a smell of gas or fumes) and cannot confirm that an appliance is safe, they may also attach a ‘Danger Do Not Use’ warning label to the installation/appliance and issue you with an appropriate warning notice. If the ESP has issued you with one of these notices, you’ll be advised not to use the appliance until an appropriately qualified Gas Safe registered engineer has checked it. It is the homeowner’s responsibility to ensure the installation is checked. The registered engineer should keep you (or your landlord where appropriate) informed of the actions they’re taking in the interests of your safety. If you have any concerns over this, you can contact the Gas Safe Register
Gas Safe Register: Help and Advice At R M Labels we offer a full range of products for identifying gas appliances, where you will find the Danger Do Not Use Safety Warning Labels and Warning Advice Notice Certificates which comply to the current regulations and are licensed by the Gas Safe Register. Link to website: R M Labels Limited
Related Publications:
Gas Industry Unsafe Situations Procedure Explained Gas Industry Unsafe Situations Procedure